how to get the best hit from a crack pipe

How to get the best hit from a crack pipe how to#

The ubiquitous BIC lighter can be found in practically any grocery or corner store. Put a flame or other heating element to the bowl, inhale, and enjoy!īutane lighters are the go-to for most weed smokers.

This allows the cannabis toward the top to maintain a burn-or cherry-while opening up airflow for easy inhalation without clogging.

Pack your herb lightly at the bottom and slightly denser at the top for an even smoke.

You can also use a screen if you have one.

Use a nice-sized chunk to stuff at the bottom of your bowl to prevent pieces from passing though.

Put the ground or broken up weed in your pipe.

Break up the weed with your hands or loosely grind it, making sure it’s evenly broken down but not too finely ground.

Get your pipe, some weed, and a lighter a grinder is optional.

How to get the best hit from a crack pipe how to#

He knew his shit.What is a cannabis grinder? How to pack and smoke a bowl or pipe: a step-by-step guide I think I'm doing it the right way, and you are not supposed to apply direct flame to the rock and burn it, you are supposed to vaporize it, that's how I was taught by my friends uncle who had been smoking for many, many years and the crack we used to get there was way better than I've had here in Chicago. I was never taught to apply direct flame, but I just tried it a little bit testing it on just a small piece just to see Bc I've seen a couple people smoking do it and blow out a decent amount of smoke, whereas I barely blow out any smoke it seems (which I figure is Bc I'm not BURNING it, I'm VAPORIZING it and also holding it in and absorbing the vapor, same as holding in an ecig hit). Now on to smoking, I was always taught to hold it straight up and down at first take a couple deep breathes, breathe out light the lighter and hit the pipe lightly while touching the flame to the rock briefly a few times as the crackle sound dies down then start heating the metal just under where the end is (under where the crack is) as you simultaneously start rotating the pipe so the crack melts evenly and also moving from the up position to the straight forward smoking position where you stay slowly inhaling and rotating the pipe most of the time, before tilting the pipe downward so any melted cocaine ends up somewhere near the smoking end and also to try and finish the hit. Yeah I was first taught to smoke crack at age 17 in Cleveland, Ohio by my friends uncle and was taught to make the pipe using a tire gauge with everything ripped off but the pipe part and if it has oil inside it (some do, the one I just bought in Chicago didn't, and ironically the choir boy they sell is silver, so no copper to burn off) once the pipe is ready and you have your choir boy filter nice and as tight as you can get it and still stuff it in the pipe, do so (I make it so it almost doesn't fit in the pipe so it scrapes any resin nice and good Bc it seems to shrink a little with use). everyone on the fourms keep saying its best to have no indirect flame as it burns everything.Īlso, people say the chore stops the residue from sliding down my pipe but no matter what method i choose to smoke, there is always residue still running down the pipe.

Īnd ive tried heating the bottom of the glass until it starts to smoke and then i move the flame to at least 1 cm in front of the entrance and sometimes have the flame on the chore for a second and take it off, i have noticed there is heaps of smoke and my hits are harder. What im more confused about is how to burn the rock, ive tried melting it onto my chore and then heating the bottom of the glass just where it is but realised i don't get much smoke off that ( by looking at how much smoke runs along the pipe). Beginner here, Ive managed to get some fishscale and cooked it using spoon method, got a nice yellow blob and waiting for it to dry now.Īfter searching around i found multiple threads saying a straight pipe with some copper from speaker wires rolled into a ball and shoved down my pipe will work best.